Keeping your tires properly inflated is great for safety and gas mileage. But when your car’s Tire Pressure Monitoring System (TPMS) alerts the driver that there’s an issue, sometimes it can also be a bit annoying. If you’ve seen that your tire pressure light is blinking, or won’t turn off, you may have a tire pressure sensor fault on your hands. And in this guide, we’re going to cover the process on how to reset your TPMS, go over some common reasons you might have to replace a tire pressure sensor, and touch on the tire pressure sensor replacement cost. If you are looking for a trusted TPMS, we also have the best TPMS system available for your safety.

Why Tire Pressure Sensors Matter
Tire pressure sensors keep an eye on how much air is inside the tires and tells if it falls below an acceptable level. And a properly functioning TPMS is critical for your safety on the road, as a low tire pressure can lead to very dangerous driving situations. The 10 Best RV Tire Pressure Monitoring System Kits In 2021 If what you want is a tire pressure monitoring system that can handle anything your RV or trailer may dish out while still keeping your tires in the best condition then you should take a look at our Liwogi T14 TPMS which is easy to install and gives you real-time monitoring you can trust.

How to Reset Your Tire Pressure Sensor

You’re driving down the highway, late for work, and all of a sudden you hear an obnoxious alert going off on your dashboard.
You might need to reset your tire pressure sensor when your TPMS warning light stays on despite your tire pressure being fine. Here’s how to reset your tire pressure sensor in five easy steps: 

1.Check Tire Pressure: Before you reset the TPMS, make sure all your tires are properly inflated to the vehicle’s recommended pressure. That number can be located on a sticker on the driver’s side door or in the vehicle owner’s manual.

2.Key in the “On” Position: Insert the key during this step and turn the ignition to the "ON" position, but don’t start the engine. Some cars make you start the engine, so consult your car manual.

3.Find the TPMS Reset Button: A lot of vehicles will automatically locate for a TPMS reset button, sometimes located under the dash or the steering post. If you don’t have one in your car, that reset may occur automatically after the pressure in the tire is adjusted.

4.Press and Hold TPMS Reset Button: Keep holding the button until the TPMS light blinks three times, and then let go. This should reset the system.

5.Drive the car: When you turn the car back on, you will need to drive your car for 10-30 minutes at highway speeds before the system will automatically calibrate to your engine and wheels. In case the light does not illuminate, the sensor is defective and needs to be replaced. Typical Reasons Why Your TPMS Light Is On

If you’ve reset the sensor and the light is still on, a tire pressure sensor fault is likely the issue. Here are some potential causes: 

Flat or Low Tire: This sensor also activates if your tire suddenly loses pressure.

Dead Battery in Sensor: The typical tire sensor will have a battery which lasts for 5-10 years. If the battery runs out, you will have to replace the sensor.

Faulty Sensor: A damaged sensor will not function as it should.

Malfunctioned TPMS System: It could be its wiring or its receiver is not functioning properly that would interfere with the sensors circulation.

If you have a faulty or damaged sensors, They are perfect for replacing your old or broken sensors. Our Liwogi TPMS is more accurate and durable – we tells you your tire pressure situation whenever you want.

When to Replace Tire Pressure Sensors
If you continue to experience problems with your TPMS even after resetting, or if your tire pressure sensors are over 10 years old, it may be time for a new tire sensor. By replacing the sensors, you maintain accurate readings and ensure your safety on the road. If you want to improve the vehicle tire pressure monitoring system, our Liwogi T14 TPMS will be your best choice.

Tire Pressure Sensor Replacement Cost

The price to replace tire pressure sensors varies depending on a few factors—such as the make and model of your vehicle. How Much Is A New Tire Pressure Sensor? Aaltogether, the average cost of a tire pressure sensor replacement can range from $50 to $150, which includes labor. If you have to replace all four sensors, that can cause the bill to rise to between $200 and $600. Replacement costs may be higher on high end/luxury vehicles with specialized sensors. 

But, by investing in high-quality sensors such as our Liwoqi TPMS you can avoid frequent replacements and indeed save money in the long run and also benefit from better performance and endurance.

Conclusion
Learning how to reset tire pressure sensor is a useful and handy skill to every car owner. If a reset doesn’t eliminate the issue, there could be a problem with the tire pressure sensor that would need to be checked and likely replaced by a professional. Remember, the cost to replace TPMS may vary, but maintaining your TPMS in good shape is as investment in your safety and car performance.

Looking for a better or more comprehensive tire pressure monitor?Maybe you should try our Liwogi T14 TPMS for more reliable and accurate readings.